![]() To enter the BIOS, start up your x86-64 hardware and repeatedly press the F2 key (on some systems this might be Del, F1 or F10). However, the options should still be present and named similarly. The BIOS menu will likely look different on your system. The following screenshots are from a 7th generation Intel NUC system. To boot Home Assistant OS, the BIOS needs to have UEFI boot mode enabled and Secure Boot disabled. Configure the BIOS on your x86-64 hardware There are two ways to do this listed below. You will need to configure your Generic x86-64 PC to use UEFI boot mode, then write the HAOS (Home Assistant OS) disk image to your boot medium. ![]() Pretty much all systems produced in the last 10 years support the UEFI boot mode. The system must be 64-bit capable and able to boot using UEFI. Install balenaEtcher on Fedora Linux sudo dnf install -y balena-etcher-electronĤ.This guide assumes that you have a dedicated Generic x86-64 PC (typically an Intel or AMD-based system) available to exclusively run Home Assistant Operating System. Get balenaEtcher rpm repository: curl -1sLf \ Uninstall balenaEtcher from RedHat/CentOS Linux (optional) sudo yum remove -y balena-etcher-electron Install Etcher on RedHat or CentOS Linux sudo dnf install -y balena-etcher-electron 4. Paste the whole given block of command and hit the Enter key. ![]() #For Redhat (RHEL), CentOS, and other same derivatives 1. Uninstall balenaEtcher (optional) sudo apt-get remove balena-etcher-electron ![]() Install balenaEtcher on Ubuntu Linux sudo apt-get install balena-etcher-electron 5. In the command terminal paste the whole block of the below command to add the Etcher repository: curl -1sLf \ #For Ubuntu, Linux Mint, Debian, ElementaryOS, and other same derivatives… 1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |